Having problem with the battery of your bike (this article is for the bikes up to 150CC), battery getting discharged frequently or having such problems?
No worries…!
Now you can replace the battery of your bike with 2-3 small capacitors of 1000uF/25 and forget about the battery of the bike.
What to do?
- First connect 2-3 capacitors in parallel with each other on a piece of simple cardboard, or zero PCB or anything like that so that the capacitors will be connected properly to each other.
- Now join two wires to the two terminals of the capacitor – one wire to +ve terminals of the capacitors and the other wire to -ve terminals of the capacitors.
- Now remove the old battery of your bike.
- While removing the battery remember which wire you disconnected from +ve & -ve terminals of battery.
- Now connect the two wires of the capacitor to respective terminals of the wires coming from the inner circuit of the bike.
- Then fit the assembly of capacitors properly inside the service box of the bike.
- Lock the box and now you are ready for starting the bike.
- Connect the key to the ignition switch of the bike and apply just a single kick to the kick shaft of the bike.
- Raise the accelerator slightly while applying kick.
- The bike should start.
- Now raise the accelerator slightly and press horn switch.
- The horn will blow.
Now you can ride the bike anywhere without worrying about the battery.
Remember the headlight and tail lights of the bike run on internal magnto of the bike.
So there is no problem during night also…!
Enjoy…!